['Welding and Cutting']
['Welding and Cutting']
05/05/2022
...
Standard Number: 1910.253
September 9, 1993
Mr. Kenneth J. Yotz
Health and Safety Consultant
Environmental, Management
And Training Systems, Inc.
Five South Andover Lane
Geneva, Illinois 60134-1806
Dear Mr. Yotz:
This is a further response to your letter of June 21, in which you requested an interpretation of the Occupational Safety and Health Administration's (OSHA's) 29 CFR 1910.253(b)(2)(iv), Oxygen-fuel gas welding and cutting, standard. Specifically, you requested whether the safe movement of the compressed gas cylinders with the regulators installed comply with the "in use" or the "connected for use" requirements of the above-mentioned standard, and whether the "special truck" requirement of 1910.253(b)(5)(ii)(D) implies any specific design criteria of the truck.
Compressed gas cylinders with the regulators installed are considered by OSHA to be "connected for use." A "special truck" is a vehicle or cart used for the specific purpose of transporting the aforementioned "connected for use" compressed gas cylinders in the workplace. The "special truck" must be designed so that the following conditions can be met: 1) when cylinders are on the special trucks, they must be held in an erect or nearly erect position; and 2) protection of the cylinder valves and regulators must be provided.
Based on the information in your letter, we believe that the procedure or practice described in your letter meets the intent of 1910.253(b)(2)(iv). The intervals at which the unit is used is not the main consideration. The critical factor that distinguishes cylinders in storage [where valve protection caps are required] from those not in storage is those not in storage must be in use or connected for use, with provisions made to protect the regulator and the valve. Also, in accordance with the requirement of 1910.253(b)(5)(ii)(G), cylinder valves must be closed when work is finished.
If we may be of further assistance, please feel free to contact [the Office of General Industry Enforcement at (202) 693-1850].
Sincerely,
Raymond E. Donnelly, Director
Office of General Industry
Compliance Assistance
[Corrected 5/19/2006]
READ MORESHOW LESS
['Welding and Cutting']
['Welding and Cutting']
Load More
J. J. Keller is the trusted source for DOT / Transportation, OSHA / Workplace Safety, Human Resources, Construction Safety and Hazmat / Hazardous Materials regulation compliance products and services. J. J. Keller helps you increase safety awareness, reduce risk, follow best practices, improve safety training, and stay current with changing regulations.
Copyright 2024 J. J. Keller & Associate, Inc. For re-use options please contact copyright@jjkeller.com or call 800-558-5011.