FREE TRIAL UPGRADE!
Thank you for investing in EnvironmentalHazmatHuman ResourcesHuman Resources, Hazmat & Environmental related content. Click 'UPGRADE' to continue.
CANCEL
YOU'RE ALL SET!
Enjoy your limited-time access to the Compliance Network!
A confirmation welcome email has been sent to your email address from ComplianceNetwork@t.jjkellercompliancenetwork.com. Please check your spam/junk folder if you can't find it in your inbox.
YOU'RE ALL SET!
Thank you for your interest in EnvironmentalHazmatHuman ResourcesHuman Resources, Hazmat & Environmental related content.
WHOOPS!
You've reached your limit of free access, if you'd like more info, please contact us at 800-327-6868.
CLOSE
 
 

...

CGA E-3 Standard for rubber welding hose and hose connections for gas welding, cutting, and allied processes

RegSenseWelding and CuttingSafety & HealthGeneral Industry SafetyConsensus StandardsIndustry Consensus StandardCompressed Gas Association (CGA)EnglishFocus AreaWelding and CuttingUSA

This standard specifies the connections on removable pipeline regulators and station outlets used in the welding, cutting and allied processes where the pipeline pressure does not exceed 200 psi. Removable connections are those that are commonly and readily engaged or disengaged in routine use and service. A regulator connected to or in the pipeline by pipe threads, bolted flanges, etc., is not considered removable.

Current edition

  • CGA E-3-2008 (R2014) Low Pressure Pipeline Station Outlet/Regulator Inlet Connection Standard, 4th Edition (Reaffirmed)

Incorporation by reference

This standard has not been incorporated by reference (IBR) into the Code of Federal Regulations (CFR).

How to purchase

Standards are available for purchase from the American National Standards Institute (ANSI), see webstore.ansi.org, and from the Compressed Gas Association (CGA), see www.cganet.com.

READ MORESHOW LESS
['Welding and Cutting']
['Welding and Cutting']
Load More