FREE TRIAL UPGRADE!
Thank you for investing in EnvironmentalHazmatHuman ResourcesHuman Resources, Hazmat & Environmental related content. Click 'UPGRADE' to continue.
CANCEL
YOU'RE ALL SET!
Enjoy your limited-time access to the Compliance Network!
A confirmation welcome email has been sent to your email address from ComplianceNetwork@t.jjkellercompliancenetwork.com. Please check your spam/junk folder if you can't find it in your inbox.
YOU'RE ALL SET!
Thank you for your interest in EnvironmentalHazmatHuman ResourcesHuman Resources, Hazmat & Environmental related content.
WHOOPS!
You've reached your limit of free access, if you'd like more info, please contact us at 800-327-6868.
CLOSE
 
 

...

CGA and RMA (Rubber Manufacturers Association) specification for rubber welding hose

RegSenseEnforcement and Audits - OSHAWelding and CuttingEnforcement and Audits - OSHASafety & HealthAssociation for Rubber Products Manufactures (ARPM)General Industry SafetyConsensus StandardsIndustry Consensus StandardCompressed Gas Association (CGA)EnglishFocus AreaWelding and CuttingUSA

This publication has been discontinued. Several publications are currently available from the Association for Rubber Products Manufacturers (ARPM) and Compressed Gas Association (CGA) that may cover these requirements:

  • ARPM IP-7 Specification for Rubber Welding Hose
  • CGA E-1 Standard for Rubber Welding Hose and Hose Connections for Gas Welding, Cutting, and Allied Processes

Current edition

  • CGA and RMA (Rubber Manufacturer’s Association) Specification for Rubber Welding Hose (1958) (Discontinued)

Incorporation by reference

The following editions have been incorporated by reference (IBR) into the Code of Federal Regulations (CFR):

1 This publication has been discontinued.
IBR approved for Overview of requirements IBR approved edition
29 CFR 1910.1910.253(e)(5)(i) Hose for oxy-fuel gas service shall comply with the Specification for Rubber Welding Hose, 1958, Compressed Gas Association and Rubber Manufacturers Association. CGA and RMA (Rubber Manufacturer’s Association) Specification For Rubber Welding Hose (1958). 1

How to purchase

Standards are available for purchase from the American National Standards Institute (ANSI), see webstore.ansi.org, the Compressed Gas Association (CGA), see www.cganet.com, and the Association for Rubber Products Manufactures (ARPM), see arpminc.com.

['Enforcement and Audits - OSHA', 'Welding and Cutting']
['Welding and Cutting', 'Enforcement and Audits - OSHA']
UPGRADE TO CONTINUE READING
Load More