FREE TRIAL UPGRADE!
Thank you for investing in EnvironmentalHazmatHuman ResourcesHuman Resources, Hazmat & Environmental related content. Click 'UPGRADE' to continue.
CANCEL
YOU'RE ALL SET!
Enjoy your limited-time access to the Compliance Network!
A confirmation welcome email has been sent to your email address from ComplianceNetwork@t.jjkellercompliancenetwork.com. Please check your spam/junk folder if you can't find it in your inbox.
YOU'RE ALL SET!
Thank you for your interest in EnvironmentalHazmatHuman ResourcesHuman Resources, Hazmat & Environmental related content.
WHOOPS!
You've reached your limit of free access, if you'd like more info, please contact us at 800-327-6868.
CLOSE
 
 

...

BS EN 13000 Cranes. Mobile cranes

RegSenseMobile CranesCranes, Lifts, and ScaffoldingEnforcement and Audits - OSHAEnforcement and Audits - OSHABritish Standards Institution (BSI)Safety & HealthConstruction SafetyDerricksConsensus StandardsIndustry Consensus StandardEnglishFocus AreaUSA

This standard covers the design and installation of safety devices, as well as maintaining and testing mobile cranes. It does not apply to lifting people.

Current edition

  • BS EN 13000:2010 A1:2014 Cranes. Mobile Cranes

Incorporation by reference

The following editions have been incorporated by reference (IBR) into the Code of Federal Regulations (CFR):

IBR approved for Overview of requirements IBR approved edition
29 CFR 1926.1433(c)(2)Employers must ensure that mobile (including crawler and truck) and locomotive cranes manufactured on or after November 8, 2010 meet the prototype testing requirements in Test Option A or Test Option B of 1926.1433. Tower cranes manufactured on or after November 8, 2010 must meet the prototype testing requirements in BS EN 14439:2006. (2) Test Option B. The testing and verification requirements of BS EN 13000:2004 must be met. In applying BS EN 13000:2004, the following additional requirements must be met: (i) The following applies to equipment with cantilevered booms (such as hydraulic boom cranes): The analysis methodology (computer modeling) must demonstrate that all load cases listed in SAE J1063 (Nov. 1993) meet the strength margins listed in SAE J1063 (Nov. 1993) Table 2. (ii) The following applies to equipment with pendant supported lattice booms: The analysis methodology (computer modeling) must demonstrate that all load cases listed in SAE J987 (Jun. 2003) meet the strength margins listed in SAE J987 (Jun. 2003) Table 2. (iii) Analysis verification. The physical testing requirements under SAE J1063 (Nov. 1993) and SAE J987 (Jun. 2003) must be met unless the reliability of the analysis methodology (computer modeling) has been demonstrated by a documented history of verification through strain gauge measuring or strain gauge measuring in combination with other physical testing.BS EN 13000:2004 Cranes - Mobile Cranes.

How to purchase

Standards are available for purchase from the American National Standards Institute (ANSI), see webstore.ansi.org, and from the British Standards Institution (BSI), see shop.bsigroup.com.

['Enforcement and Audits - OSHA', 'Cranes, Lifts, and Scaffolding']
['Mobile Cranes', 'Derricks', 'Enforcement and Audits - OSHA']
UPGRADE TO CONTINUE READING
Load More