[]
[]
07/25/2021
Copyright 2024 J. J. Keller & Associate, Inc. For re-use options please contact copyright@jjkeller.com or call 800-558-5011.
...
[Editor’s Note: This section is removed and reserved effective January 1, 2022.]
(a)Credit use.Credits may be used to meet the applicable refinery or importer annual average sulfur standards under§80.195,§80.216, or§80.240, or may be used to meet the offset requirement under§80.271(d)(1)for any refinery with an adjustment of itsper-gallon cap standard pursuant to §80.271(a), provided that:
(1) Sulfur credits used were generated pursuant to the requirements of this subpart; and
(2) The requirements of paragraphs (b) and (c) of this section are met.
(b)Credit transfers.(1) Credits obtained from other persons may be used to meet the annual average standards specified in§80.195,§80.216, or§80.240, or may be used to meet the offset requirement under§80.271(d)(1)for any refinery with an adjustment of itsper-gallon cap standard pursuant to §80.271(a), if all the following conditions are met:
(i) The credits are generated and reported according to the requirements of this subpart.
(ii) The credits are used in compliance with the limitations regarding the appropriate periods for credit use in this subpart.
(iii) Any credit transfer takes place no later than March 31 following the calendar year averaging period when the credits are used.
(iv) No credit may be transferred more than twice: The first transfer by the refiner or importer who generated the credit may only be made to a refiner or importer who intends to use the credit; if the transferee cannot use the credit, it may make the second, and final, transfer only to a refiner or importer who intends to use the credit. In no case may a credit be transferred more than twice before being used or terminated.
(v) The credit transferor must apply any credits necessary to meet the transferor's applicable average standard before transferring credits to any other refiner or importer.
(vi) No credits may be transferred that would result in the transferor having a negative credit balance.
(vii) Each transferor must supply to the transferee records indicating the years the credits were generated, the identity of the refiner or importer who generated the credits, and the identity of the transferring party, if it is not the same party that generated the credits.
(2) In the case of credits that have been calculated or created improperly, or are otherwise determined to be invalid, the following provisions apply:
(i) Where a refiner's baseline has been determined to be incorrect under§80.250(c)or §80.290(f), any credits generated, banked, used or traded must be adjusted to reflect the corrected baseline.
(ii) Invalid credits cannot be used to achieve compliance with the transferee's averaging standard, regardless of the transferee's good faith belief that the credits were valid.
(iii) The refiner or importer who used the credits, and any transferor of the credits, must adjust their credit records and reports and sulfur calculations as necessary to reflect the proper credits.
(iv) Any properly created credits existing in the transferor's credit balance after correcting the credit balance, and after the transferor applies credits as needed to meet the average standard at the end of the compliance year, must first be applied to correct the invalid transfers before the transferor trades or banks the credits.
(c)Limitations on credit use.(1) Credits generated prior to 2004 may only be used for demonstrating compliance with the refinery or importer annual average standards under§80.195during the 2005 and 2006 averaging periods. Such credits may be used to demonstrate compliance with the standards under§80.216during the 2004 through 2006 averaging periods, and with the standards under§80.240during the 2004 through 2007 averaging periods, and the 2008 and 2009 averaging periods, if allowed under the terms of a hardship extension under§80.265.
(2) Credits generated in 2004 or later may only be used for demonstrating compliance with standards during an averaging period within five years of the year of generation.
(3) A refiner or importer possessing credits must use all credits prior to falling into compliance deficit under §80.205(e).
(4) Credits may not be used to meet corporate pool average standards under§80.195.
[65 FR 6823, Feb. 10, 2000, as amended at 67 FR 40184, June 12, 2002; 80 FR 9095, Feb. 19, 2015; 85 FR 78467, Dec. 4, 2020]
READ MORESHOW LESS
Load More
J. J. Keller is the trusted source for DOT / Transportation, OSHA / Workplace Safety, Human Resources, Construction Safety and Hazmat / Hazardous Materials regulation compliance products and services. J. J. Keller helps you increase safety awareness, reduce risk, follow best practices, improve safety training, and stay current with changing regulations.
Copyright 2024 J. J. Keller & Associate, Inc. For re-use options please contact copyright@jjkeller.com or call 800-558-5011.