FREE TRIAL UPGRADE!
Thank you for investing in EnvironmentalHazmatHuman ResourcesHuman Resources, Hazmat & Environmental related content. Click 'UPGRADE' to continue.
CANCEL
YOU'RE ALL SET!
Enjoy your limited-time access to the Compliance Network!
A confirmation welcome email has been sent to your email address from ComplianceNetwork@t.jjkellercompliancenetwork.com. Please check your spam/junk folder if you can't find it in your inbox.
YOU'RE ALL SET!
Thank you for your interest in EnvironmentalHazmatHuman ResourcesHuman Resources, Hazmat & Environmental related content.
WHOOPS!
You've reached your limit of free access, if you'd like more info, please contact us at 800-327-6868.
CLOSE
 
 

...

SEARCH

Rear Bumper/Rear Underride Guards - North Dakota

RegSenseState InfoFleet SafetyCMV Parts and MaintenanceBest ResultsFocus AreaEnglishNorth DakotaTransportationRear bumper

North Dakota has adopted 393.86 of the Federal Motor Carrier Safety Regulations (FMCSRs).

In North Dakota, the bumper's height must not exceed 27 inches, and this measurement is made from a level ground surface to the highest point on the bottom.

A horizontal drop bumper may be used to comply with this requirement and must:

  • Be at least three inches in vertical width;
  • Extend the entire horizontal body width; and
  • Be horizontal, load bearing, and attached to the vehicle frame to effectively transfer impact when engaged.

Related information

Citations

['CMV Parts and Maintenance']
['Rear bumper']
UPGRADE TO CONTINUE READING
Load More