['Toxic Substances Control Act - EPA']
['Toxic Substances - EPA', 'Toxic Subtances Control Act - EPA']
07/05/2023
...
(a) Chemical substance and significant new uses subject to reporting.
(1) The chemical substance identified generically as isocyanate compound, modified with methoxysilane (PMN P-01-918) is subject to reporting under this section for the significant new uses described in paragraph (a)(2) of this section.
(2) The significant new uses are:
(a)(2)(i) Protection in the workplace. Requirements as specified in §721.63, (a)(2)(i), (a)(2)(ii), (a)(2)(iii), (a)(2)(iv), (a)(3), (a)(4), and (a)(6). The following National Institute for Occupational Safety and Health (NIOSH)-approved respirators meet the minimum requirement for §721.63(a)(4): Air-purifying, tight-fitting full- face respirator equipped with N100 (if oil aerosols absent), R100, or P100 filters; powered air-purifying respirator equipped with a tight- fitting full facepiece and High Efficiency Particulate Air (HEPA) filters; supplied-air respirator operated in pressure demand or continuous flow mode and equipped with a tight-fitting full facepiece. As an alternative to the respiratory requirements listed here, a manufacturer, importer, or processor may choose to follow the new chemical exposure limit (NCEL) provisions listed in the TSCA section 5(e) consent order for this substance. The NCEL is 0.05 mg/m\3\ as an 8-hour time-weighted average. Persons who wish to pursue NCELs as an alternative to the §721.63 respirator requirements may request to do so under 40 CFR 721.30. Persons whose §721.30 requests to use the NCELs approach are approved by EPA will receive NCELs provisions comparable to those contained in the corresponding section 5(e) consent order.
(a)(2)(ii) Hazard communication program. Requirements as specified in §721.72, (b), (c), (d), (e) (concentration set 1.0 percent), (f), (g)(1)(i), (g)(1)(ii), (g)(2)(i), (g)(2)(ii), (g)(2)(iv) (use respiratory protection or maintain workplace airborne concentrations at or below an 8-hour time-weighted average of 0.05 mg/m\3\), (g)(2)(v), and (g)(5). The following statements shall appear on each label as specified in §721.72(b) and the Material Safety Data Sheet (MSDS) as specified in §721.72(c): This substance may cause skin irritation and sensitization.
(a)(2)(iii) Industrial, commercial, and consumer activities. Requirements as specified in §721.80(q).
(b) Specific requirements. The provisions of subpart A of this part apply to this section except as modified by this paragraph.
(b)(1) Recordkeeping. Recordkeeping requirements as specified in §721.125, (b), (c), (d), (e), (f), (g), (h) and (i) are applicable to manufacturers, importers, and processors of this substance.
(b)(2) Limitations or revocation of certain notification requirements. The provisions of §721.185 apply to this section.
(b)(3) Determining whether a specific use is subject to this section. The provisions of §721.1725(b)(1) apply to this section.
[72 FR 14697, March 29, 2007]
READ MORESHOW LESS
['Toxic Substances Control Act - EPA']
['Toxic Substances - EPA', 'Toxic Subtances Control Act - EPA']
Load More
J. J. Keller is the trusted source for DOT / Transportation, OSHA / Workplace Safety, Human Resources, Construction Safety and Hazmat / Hazardous Materials regulation compliance products and services. J. J. Keller helps you increase safety awareness, reduce risk, follow best practices, improve safety training, and stay current with changing regulations.
Copyright 2024 J. J. Keller & Associate, Inc. For re-use options please contact copyright@jjkeller.com or call 800-558-5011.