FREE TRIAL UPGRADE!
Thank you for investing in EnvironmentalHazmatHuman ResourcesHuman Resources, Hazmat & Environmental related content. Click 'UPGRADE' to continue.
CANCEL
YOU'RE ALL SET!
Enjoy your limited-time access to the Compliance Network!
A confirmation welcome email has been sent to your email address from ComplianceNetwork@t.jjkellercompliancenetwork.com. Please check your spam/junk folder if you can't find it in your inbox.
YOU'RE ALL SET!
Thank you for your interest in EnvironmentalHazmatHuman ResourcesHuman Resources, Hazmat & Environmental related content.
WHOOPS!
You've reached your limit of free access, if you'd like more info, please contact us at 800-327-6868.
CLOSE
 
 

...

Table 4 to Subpart MMMMM of Part 63 - Initial Compliance With Emission Limits

RegSenseCFR RegulationsEnvironmental Protection Agency (EPA)Hazardous Air PollutantsEnvironmentalAir QualityFocus AreaUSAEnglishAir ProgramsCFR Appendix

As stated in §63.8806, you must comply with the requirements to demonstrate initial compliance with the applicable emission limits in the following table:

For . . .For the following emission limit . . .You have demonstrated initial compliance if . . .
1. Each new, reconstructed, or existing loop slitter adhesive use affected sourceEliminate use of HAP-based adhesivesYou do not use HAP-based adhesives.
2. Each new or reconstructed flame lamination affected source using a scrubberReduce HAP emissions by 90 percentThe average HAP emissions, measured over the period of the performance test(s), are reduced by 90 percent.
3. Each new or reconstructed flame lamination affected source using any other control device emissions byReduce HAP emissions by 90 percentThe average HAP emissions, measured over the period of the performance test(s), are reduced by 90 percent.
4. Each existing flame lamination affected sourceEmit no more than 1.45 pounds per hour of HCl per flame lamination lineThe average HCl emissions, measured over the period of the performance test(s) do not exceed 1.45 pounds per hour per flame lamination line.

[86 FR 64403, Nov. 18, 2021]

['Air Programs']
['Hazardous Air Pollutants']
UPGRADE TO CONTINUE READING
Load More