Compliance Just Got Easier: Stay ahead of regulatory changes with instant notifications on updates that matter.

LEARN MORE

FREE TRIAL UPGRADE!
Thank you for investing in EnvironmentalHazmatHuman ResourcesHuman Resources, Hazmat & Environmental related content. Click 'UPGRADE' to continue.
CANCEL
YOU'RE ALL SET!
Enjoy your limited-time access to the Compliance Network!
A confirmation welcome email has been sent to your email address from ComplianceNetwork@t.jjkellercompliancenetwork.com. Please check your spam/junk folder if you can't find it in your inbox.
YOU'RE ALL SET!
Thank you for your interest in EnvironmentalHazmatHuman ResourcesHuman Resources, Hazmat & Environmental related content.
WHOOPS!
You've reached your limit of free access, if you'd like more info, please contact us at 800-327-6868.
CLOSE
 
 
Institute Safety & Health General Industry Safety Tool Safety Test Yourself Answers Tool Safety English Analysis Focus Area USA

Ensuring tool safety and compliance in the workplace: Answers

  1. Yes. A tool retainer must be installed on each piece of equipment that would otherwise eject the tool without a retainer.
  2. No. High-velocity tools must be designed so it cannot be fired unless it is equipped with a standard protective shield or guard, or special shield, guard, fixture, or jig.
  3. 2 inches
  4. No. OSHA states in 1910.243(d)(4(vi) that a tool shall never be left unattended in a place where it would be available to unauthorized persons.
  5. No. OSHA requires any tool not found in safe working order be removed from service.
tool-safety
Tool Safety
tool-safety
Tool Safety
Institute Safety & Health General Industry Safety Tool Safety Test Yourself Answers Tool Safety English Analysis Focus Area USA

Ensuring tool safety and compliance in the workplace: Answers

Institute Safety & Health General Industry Safety Tool Safety Test Yourself Answers Tool Safety English Analysis Focus Area USA
  1. Yes. A tool retainer must be installed on each piece of equipment that would otherwise eject the tool without a retainer.
  2. No. High-velocity tools must be designed so it cannot be fired unless it is equipped with a standard protective shield or guard, or special shield, guard, fixture, or jig.
  3. 2 inches
  4. No. OSHA states in 1910.243(d)(4(vi) that a tool shall never be left unattended in a place where it would be available to unauthorized persons.
  5. No. OSHA requires any tool not found in safe working order be removed from service.
2658511910
Answer
UPGRADE TO CONTINUE READING